R33 N/A to RB25det?

[GTRKiiNG]

Well I'm sorry, this is probably more than likely a repost but need to find out as soon as possible and as much as I can find out! Been thinking of buying an r33 2.0 N/A and then putting an RB25 in it. What do I need and what sort of money am I looking to spend, not looking for a mad spec engine fairly stock with a stock turbo etc. who'd be the cheapest and best person to do it in the Leinster area I'm living in carlow if anyone can recommend somebody nearby.
Again sorry for the repost.
Thanks
Chris

[AndrewR32]

you'd buy a r33 gtst for around the same price

r33 na - around €1500 for a good clean one

rb25det engine, box, loom, ecu, prop, brakes, fuel pump, fmic will cost you close to 2k if bought seperately.

a decent spec r33 gtst would cost you around 3500-4000

[GTRKiiNG]

you'd buy a r33 gtst for around the same price

r33 na - around €1500 for a good clean one

rb25det engine, box, loom, ecu, prop, brakes, fuel pump, fmic will cost you close to 2k if bought seperately.

a decent spec r33 gtst would cost you around 3500-4000

Yeah i knew it would be in around that price but the N/A car is sorted and getting it for good money thats why I was looking to go down this road?

[AndrewR32]

a full conversion is had to come by. what i'd be looking our for is a rough r33 gtst or crash damaged car. you'll need a nice bit of the car for the full conversion.

rough individual prices
Engine - €1000
Turbo - €250
Gearbox - €600
prop - €100
front and rear brake setup - €300
front and rear 5stud hubs - €150
Engine loom - €100
ECU - €80
Fuel pump - €50-80

[GTRKiiNG]

a full conversion is had to come by. what i'd be looking our for is a rough r33 gtst or crash damaged car. you'll need a nice bit of the car for the full conversion.

rough individual prices
Engine - €1000
Turbo - €250
Gearbox - €600
prop - €100
front and rear brake setup - €300
front and rear 5stud hubs - €150
Engine loom - €100
ECU - €80
Fuel pump - €50-80

Thanks for the info man much appreciated! Big job putting it in do you know? Would a mechanic and a few helpers get it done would you think?

[AndrewR32]

Its pretty much plug and play for engine loom. you may need a boost controller as oem might be tricky to plumb.

The rest you'd do with a few hands over a weekend / (long saturday)

[WayneR33]

Have a good Rb25 bottom end there, fully rebuilt all new rings bearings rod bolts ect take €500 if its any good to ye?

[GTRKiiNG]

Have a good Rb25 bottom end there, fully rebuilt all new rings bearings rod bolts ect take €500 if its any good to ye?

Wont be able to buy any parts at the minute till I sort a few things out but I'll deff drop you a PM when I'm looking for the parts n see do you still have it.