Break pistion rubber seal.need help really bad

[rico180]

I need serious help here lads. I bought skyline rear breaks here awhile ago, and i just noticed the the rubber seal around the pistion is spilt. I went into Nissan and I got the usual " it can't be got" shit!!!.
Is here any other kits I could buy to fix this? Or is there a specialist any where in the country I could get in contact with to fix them for me. I really would prefer to repair these than to scrap these just because of a rubber thingy. I also payed good money for them too.

[Darren]

give Pat Tiernan Motors a shout. i'm shure if they can be got they can get them

[paddyb01]

is it the seal on the piston or just the dust cover?
you can get repair kits seen them on ebay before.
bad form by the seller

[rico180]

I'am not sure what's it called exactly, it's the rubber lad around the pistion.ill try get pictures up. I was lookin at them kits on google, but I don't know witch one's I should be buying. The calliper Has no numbers or markings. I was kind of hopein they would share the rubber as a mica, or almera or something and someone might have a part number for it.

[rico180]

give Pat Tiernan Motors a shout. i'm shure if they can be got they can get them

I am going to pm now and see. There has to be a Nissan garage some where in the world , that has this kit sitting on a shelve!!

[babyeater690]

its the dust boot as you wouldn see a rip in the seal
you can order these on ebay for most cars and if you cant find one for the skyline just take it off and get the full size and match it up with one from another car alot of the japs are the same or similar

[rico180]

Here are the pictures of the calipers

[paddyb01]

its only the dust cover you'll prob get one handy

[rico180]

I've gone to every motor factor's around and I can't get them . Only on line, and I don't know what type!

[darren C]

stick it on as is and sort one out later not exactly the end of the world 10 minute job on the car afterwards