My R32 4door track/drift project

[AndrewR32]

Picked this up from grange last weekend. Since finishing (nearly) my r32 road project, i found myself bored, so wanted something to keep me busy for the winter (not sure how many winters i'll need, but will keep me busy anyway).

Plans:
Get it fixed up, and then have some fun!

Needs plenty of work, but have a crap load of parts left over from the few cars i broke, which helps!

Anyway, here is how it stands:

[cobcorsa]

cool base ya got , the glass in them things are the worst to get and it seems you have all the glass so its a good start, if ur looking for a body kit ill be selling my one if ur interested

[AndrewR32]

think i have my eye on one, but nothing set in stone

the windscreen is cracked, but im not worried about that.

[driftescort]

As I have already said, wish I had the time/money to do something with this.

Good luck with it Andrew.

[grange]

Best of luck with it. It was a nasty day to load her up!

[AndrewR32]

Got her into the garage over the weekend and managed to start the ripping this evening.

Front subframe and suspension off:

[AndrewR32]

Jesus....

6 months since an update? and doesnt look much different. although the garage corner isnt so tidy these days.

So far i've the following bought:

Engine:
RB25DET Spec 1
SARD FPR
Front mount intercooler
Toyo Oil Cooler with Relocation
55mm Alloy Rad
GTR Fuel Pump
3in stainless downpipe

Front Suspension:
R33 Subframe
R33 P/S Pump, rack, etc
R33 Tie Rods & Ends
Driftworks Camber Arms
Driftworks Tension Arms
Driftworks Lower Arms
MDU Coilovers
5 Stud Conversion
R32 GTR front brake setup
Completely polybushed
Driftworks braided clutch, hydro and brake lines

Rear Suspension:
Non Hicas Subframe
Driftworks Solid Subframe Bushes
Adjustable Camber Arms
Adjustable Caster Arms
Adjustable Toe Arms
5 Stud Conversion
MDU Coilovers
R32 GTR Rear Brakes
Hydraulic Handbrake
Completely polybushed
Driftworks braided hydro and brake lines

Electrics/Gadgets/etc:
Twin 12in elec fans
HKS EVC Boost Controller
HKS 52mm water temp gauge
HKS 60mm boost gauge
Loads of toggle switches, cut off switch, etc
Z32 ECU
Z32 AFM


Interior, etc:
Manual pedalbox conversion
Dished steering wheel, snap off kit and boss kit

Exterior:
Full Vertex Kit
Fibreglass Bonnet


How it was sitting before fitting coilovers (sitting on bilstein suspension)




I hope to get alot more done next week while on holidays

[Sir Diffsalot]

ya need to get this sorted and get driftin

[grange]

haha ye the back of the van was full with everything to finish this the last time we met

[Johnnyghia]

Any updates Andrew.