Anyone running 16"s on an altezza?

[keepersideways]

as above? a few sets have caught my eye but not sure will it look odd or even work!

[dermot-r32]

as above? a few sets have caught my eye but not sure will it look odd or even work!

would wana be super low to work IMO,what kind of wheels offset etc would make a huge differnce obviously

[keepersideways]

sitting like this at the mo, can prob go a tiny bit lower at the back before the back box starts catching, guna go a touch lower on the front too,, guna test fit a set of 98spec dc2 wheels to see how they suit? should fit over the calipers i hope

[dermot-r32]

sitting like this at the mo, can prob go a tiny bit lower at the back before the back box starts catching, guna go a touch lower on the front too,, guna test fit a set of 98spec dc2 wheels to see how they suit? should fit over the calipers i hope

IMO if it was to work you'd want to have it as low as possible and run wide wheels. 9j with a good offset but ive never really seen 16s in them kind of sizes? id personally love a tezz with banded steelies

my 2cent lad.tis a lovely tezz you have too man!!!

[tezdude]

You would have to go seriously low with a really low offset dished wheel to make it work!Arches on altezza's are big and most aftermaket backbox's hang very low on them so youll have a job on your hands!

[slithertooth]

Have a set of oem r32 gtr wheels that came off a tez... 16x 8 looked wicked imo think they were 205/50

[keepersideways]

the way its sitting at the moment my hks is bout 3 inches off the ground on a good road..
finding it hard to get different wheels to every other altezza and in the right size/fitment/offset