gav's instant lifestyler hardparker kouki 180 build!!!

[D-turbo-lad]

jesus i dont know bout getting sand paper to the lights i know 1000 or 1200 water paper might be all right buh dont reali want to riisk it just yet but could be an option if all comes to all ...

[D-turbo-lad]

bit of an update nothing much ..
odrered a rear strut brace off 180sxBraker this eve and was on driftworks ealier and had a few pound so instead a me goin make up all new copper pipes for the hydro i bought braided lines pre made and a fancy looking little drift button for the normal handbrake
so will have pics and progress up then they come

[Mac_C]

Bit of nitromors paint removal and a cloth should lift it lad

Haven't seen paint it didnt lift yeat

[D-turbo-lad]

Bit of nitromors paint removal and a cloth should lift it lad

Haven't seen paint it didnt lift yeat

ya i knw well .. buh jez say that stuff id melt the lights .. 1200grit sandpaper il ave ta be used 1st for thre try

[Mac_C]

Never used it on plastic before in fairness dont know what effect it would have on it ,
Have a bit of bumper trim that was color coded and looks like fuck all going to remove it with nitro tomarra , will let ya know if damages plastic

[Shane_s]

if ur goin at the lights with sandpaper id start with 2000 wet & dry dude, just to be safe!bit of elbow grease then compound or polish or both!

[D-turbo-lad]

rite lads got my lights sorted to day and last nite .. got 2000 grit no good .. so got 240grit water paper worked throught and then cleand them up with 2000 them came out nearly good as new have to be give a good clean tomorrow with lacqure them and polish them up .. will put up all the pictures to morrow

[paddy_last]

Sandpaper, I was going to try this on mine but I didn't think I'd get them back smooth and clear. Can't wait to see how they turned out

[D-turbo-lad]

finally got round to stick up pics of how the lights came out pics of other bits as well ..
[IMG][/IMG]

during the hours of sanding that it took

[IMG][/IMG]

finished

[IMG][/IMG]

close up

they yet have to be 2000again and laquered to bring them out well

[IMG][/IMG]

the 2 braided line that came from driftworks this morning

[paddy_last]

Lights look a 100 times better, they turn out very well so far. I'll be following what you did with mine now keep up the good work