Rota gtr's

[Paudie]

Getting a set of rota gtr's for my 180sx just want to know what width and offset would I need.

[bart]

have you standard wings and rear over fenders?

[Paudie]

Ya all standard

[skinnynphats200]

A 17 X 9 should fit grand with a small flare

[Paudie]

what off set should i go for?

[skinnynphats200]

I put a 17 X 10 et 12 on the rear of my 32 with standard arches just rollled/small flare and they fit not a bother...

The 17 X 9s only come in et25

[stevokr32]

i had et35 on my r32 they were 18 x 9.5 front and back.arches needed to be a little bit of rolling. i had a 225 front and rear with a stretch tyre.but id try a go as bit bigger to save kerbage.

[rico180]

make sure you get the dished in type. i had 17x9 et25(25mm spacer on back) and they were just about enough on my wide arch 180, so you might have to roll your wings.

[jap scrap]

Go for et 12 on a 17 x 9j rim will look good with the car droped on them

[Johnie]

It depends on how much camber you have, how low the car is and weather you want to roll your arches or not. I have 17x9.5 et 26 on the back of my car and it was fine with standard arches with the lip rolled, until I straightened the camber then I had to roll the arches out.